C2426 BMW Fault Code

Description:

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to BMW PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

C2426 Code Symptoms :

If your C2426 check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C2426 and engine control unit are in charge of monitoring a bunch of different , and if they get a reading that's a little out of whack, up pops the check engine light.

Diagnosis And Repairing C2426

C2426 OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

How to fix C2426 code ?

• EVAP canister or fuel tank leaks
• Exhaust gas leaks
• Fuel tank leaking
• Damaged camshaft position (CMP) sensor

One example of this would be when an bmw automatic car in placed in gear. To prevent the added drag from the torque converter and transmission from reducing the idling speed, the PCM will command the idle control valve to allow more air to enter the engine, while at the same time, adjusting the injector pulse width to inject more fuel to suit the increased amount of air. Note that the idle air control valve is closed by the PCM when the throttle plate is opened to prevent excess air from entering the engine.